The machine was originally plagued with constant extruder clicking during high-speed printing, which was eventually traced back to this increased friction. The spool holder was a bit too wide and actually created too much friction with the provided spool. This sounds easy, but we found that the filament spool holder supplied with our machine was not ideal, even for the included PLA filament spool. The filament spool will then rest on this part allowing it to spin freely and continue to feed filament during normal operation. The filament spool holder has a tab that can be inserted into the rear panel of the machine. The filament guide tube plugs into the extruder body and then attaches to the rear of the Replicator 2. The two important items of interest are the filament guide tube and the filament spool holder.
READY MAKER NEEDS CONNECTION TO IMPORT MANUAL
These are also described in Makerbot’s User Manual as mentioned above.
READY MAKER NEEDS CONNECTION TO IMPORT INSTALL
The Replicator 2 comes with several additional pieces you will need to install before performing your first print. If you’re confident your printer is ready to go, you can jump directly to the Software Setup Instructions. The remainder of this page is written specifically for the Replicator 2, but the same process can be applied to the other Makerbot-style printers like the Replicator 1, Replicator 2X, MBot Cube, Flashforge Creator, etc.īefore we dive into the software, there are a few final hardware checks you should perform before using your Replicator 2. You can also download an electronic copy of the User Manual directly from Makerbot’s Support Page. This describes the unboxing and final assembly including installing the filament guide tube and filament spool holder. If you are setting up a brand new Replicator 3D printer, make sure to read the User Manual that comes with the printer. The printer comes with an integrated LCD interface as well as an onboard SD card that makes printing a piece of cake. The Replicator® 1 was released in January 2012, the Replicator® 2 in September 2012, and finally the Replicator® 2X experimental printer in January 2013. The Replicator® line of 3D printers has been incredibly successful for Makerbot®.
This page will help you set up your new Makerbot® 3D printer to use the All-In-One 3D printing software by Simplif圓D™.
0 kommentar(er)
